Anyway, I thought I'd start off a new post with something I did this morning - make a lampshade for one of the bedrooms.
It took me about 30-45 minutes in total, and looks great - it was really straightforward and quite quick to do, and I'm fairly sure anyone could do it.
I used some left-over material I had from making the curtains and bedspread (in the background), and thought this was a good way to both use up the material, and create a lampshade that would match the room decor.
You will need:
- A lampshade kit or its components (I purchased a 20cm diameter drum one from NeedCraft, but you can purchase them online from eBay or other sites).
- Material of your choice (or I suppose it could also be a drawing or artwork you like). Make sure it is not creased (you may want to iron it beforehand).
- Scissors.

Unfold the lampshade backing and place face up across the material. Cut the material into an (oversized) piece of material that you can easily manage (i.e. not too big).
Turn the material over, so the pattern you want to see on the outside of the lampshade is face down. Taking about 10 cm at a time, gradually peel off the protective sheet and press the plastic down onto fabric, brushing down and removing any bubbles or creases so that the fabric sits perfectly onto the plastic. Continue until the whole sheet is stuck to the fabric.
Using the scissors or a sharp knife, trim the material so that the edge around the plastic is neat. I kept about 5mm spare little down one of the short edges (I'll explain why below).
Bend along the long edges where there is a slight perforation (about 1 cm in, either side). You will hear the plastic snap as the perforation breaks. Slowly peel away the plastic strip both ends and discard. You'll be left with a strip of material either side of the plastic (as above).
On the side where the 5mm overhand of material is, use the double-sided sticky tape to stick down this small strip onto the back of the plastic. This will give you a neat edge on the finished product. Leave the protective strip on the sticky tape.
Next, add put a strip of tape all the way around the edge of the lampshade rims. The tape should be stuck to the centre of the rim, so that there is an overhang of tape either side.
Do this for both rims.
Remove the protective strip on the tape, and stick the rim along the top of the plastic.
Do this with both rims at the same time. The tape is quite sticky, so go slowly and steadily.
Continue to roll the rims along the top of the plastic, and they will pick up the material.
When you get to the end with the tape, peel of the protective layer and stick the two ends together and press along it for a firm hold.
Fold the overhanging material over the exposed rim, the material will stick to the tape. Using the edging tool in the pack, push the material down into the crevice to neaten up the shade. Do this all the way around both sides of the shade.
After you've neatened up the edges, you should have the finished product. Fix to a ceiling rose or side lamp and Hey Presto! You've made your own lampshade!
See, I told you it was easy :)